This is the newest Power Supply Board, that will fit a lot of the most current Norcold Models. Be sure before you place the order, that your Main Power Supply Board, has one of the part numbers listed below stamped on your original Norcold Board .
This universal circuit board comes with a very simple instruction on how to plug in jumper to apply it to your particular model. This Dinosaur Electronics board replaces Norcold Circuit Board numbers: 621267, 621267.001, 621268, 621268.001, 621269, 621269.001, 621270, 621270.001, 621271, 621271.001, 619353, 619360, 619361, and 632168.001 No exceptions !
Once you have the Main Power Board ready to install be sure you have double checked the jumper location setting according the part number of the defective board with detailed information attached to the paper work of your new replacement Norcold Main Power Board.
This is a very much less expensive and a much more reliable replacement PC board than the original Norcold replacement boards. (IF you could even find them. Many are no longer being made, and they will try to sell you an entire new refrigerator unit.)
Warranty is 3 years
The original Norcold will only come with a 1 year warranty.
This Main power supply circuit board for Norcold RV Refrigerators is made by Dinosaur Electronics.
This Dinosaur Electronics N911 The Dinosaur Electronics Board "N911" Built For older 900's, 9100's, and early 1200's
This is the newest Power Supply Board, that will fit a lot of the most current Norcold Models. Be sure before you place the order, that your Main Power Supply Board, has one of the part numbers listed below stamped on your original Norcold Board .
This universal circuit board comes with a very simple instruction on how to plug in jumper to apply it to your particular model. This Dinosaur Electronics board replaces Norcold Circuit Board numbers: 618198, 618224, 618574, 618575, 618828, and 619378
Once you have the Main Power Board ready to install be sure you have double checked the jumper location setting according the part number of the defective board with detailed information attached to the paper work of your new replacement Norcold Main Power Board.
This is a very much less expensive and a much more reliable replacement PC board than the original Norcold replacement boards. (IF you could even find them. Many are no longer being made, and they will try to sell you an entire new refrigerator unit.)
3 year manufacturer limited warranty policy is enclosed to be filled out and mailed in.
The original Norcold will only come with a 1 year warranty.
This is the replacement upper condenser coils fan switch. This switch is a normally open switch that is closed by surface temperture close to 130 degrees, plus or minus a few degrees. This switch will activate the cooling unit fans. The temp setting for activating the fans with this switch is a little lower than the OEM's fan switch.
We feel it is better to have, when needed, the fan air flow starting before the cooling unit preformance starts to fail.
This switch is use to replace the OEM's installed switch at the time of failure or to be added to refrigerator coils when adding your own fans.
None operating fans, either from bad switch or bad fans, are the most common problem an cause of early cooling unit failure.
This is a replacement burner for the Norcold Refrigerators that have the 5 slot burner. It will come to you with orifice and seal. It will be ready to install.
This is a Replacement or an additional add-on fan for the Norcold Refrigerators, a must for refrigerators used in all slide outs. If you have a bad fan, this would be the replacement needed. If you are getting bad cooling preformance, be sure to confirm that the fans are running during your use. The lack of good flow of air through the back side cooling unit coils is the most common cause of cooling unit failure. The lack of needed air flow will cause your cooling unit to over heat and a failure will happen.
On all Norcold Refrigerators used in any slide out room there are fans, either factory installed or optional added for better AIR flow, through the lower loops and the upper condenser fins for max cooling preformance.
Added fans are the easiest way to increase the cooling ability of your refrigerator. The more heat that's removed from the coils back side, the cooler the inside food zone will be. The OEM Norcold cooling units must have two fans, but the Amish Built Norcold Cooling Units only need one of these fans.
These fans are 12 VDC with .950A draw. Smooth DC brushless operation with Ball Bearings
If you need to also replace the switch, here's the link:
